Under normal operation condition, the clutch is tightly engaged and there is no "slip" phenomenon. But the automobile clutch is a part of the automobile with frequent friction. With the increase of using time, the clutch is more likely to slip. If the driver does not know the front wheel of the clutch slip, when the clutch slips, the automobile cannot start. It is important to note that the replacement of the clutch plate must be carried out in the repair shop and the driver cannot repair it himself. Is there any way to predict clutch slip?

　　想想，有以下情況，離合器可能已經出了故障:

　　Consider that the clutch may have failed:

　　1.在標準條件下，車輛不能達到速度。

　　1. Under standard conditions, the vehicle cannot reach the maximum speed.

　　2.在快速加速的情況下，發動機轉速迅速提高，而車輛加速滯后，加速下降。

　　2. In the case of rapid acceleration, the engine speed increases rapidly, while the vehicle acceleration lags behind and the acceleration decreases.

　　3.長時間行駛在山路上，車輛會有一種很明顯的異味。

　　3. When driving on the mountain road for a long time, the vehicle will have a very obvious peculiar smell.

　　當車輛開始松開離合器踏板時，應將離合器舉得很高。

　　When the vehicle begins to release the clutch pedal, raise the clutch very high.

　　如果汽車出現上述情況，很可能是滑動離合器的故障。一個簡單而有效的方法確定離合器滑動現象:定期啟動引擎,放在個齒輪,不釋放拉手閘,慢慢抬起離合器,直到所有電梯,如果車輛立即關閉汽車將證明汽車的離合器沒有滑動的問題,相反,應該修理汽車的離合器。

　　If the car has the above situation, it is likely to be the fault of the slip clutch. A simple and effective method to determine the clutch sliding phenomenon: start the engine regularly, put it on the first gear, do not release the handle brake, slowly lift the clutch until all elevators, if the vehicle closes the car immediately, it will prove that the clutch of the car does not slide. On the contrary, the clutch of the car should be repaired.

　　那么，如何防止汽車離合器打滑呢?

　　So, how to prevent the clutch from slipping?

　　正確使用離合器是防止離合器過早打滑的關鍵。在學習開車的時候，許多教練提醒他們的學生不要一直踩著離合器，但是很多人無法改變這個習慣。但長期將腳放在離合器上會造成離合器半聯動，使離合器一直處于摩擦狀態，其結果會引起離合器盤燒蝕，甚至會使離合器壓盤和飛輪燒蝕，造成離合器俗稱“打滑”。同時也會導致燃油的成本上升，增加汽車的成本。

　　Correct use of the clutch is the key to prevent the clutch from slipping too early. When learning to drive, many coaches remind their students not to step on the clutch all the time, but many people cannot change this habit. However, if the foot is placed on the clutch for a long time, it will cause the clutch to be semi linked and keep the clutch in a friction state. As a result, it will cause the erosion of the clutch disc and even the erosion of the clutch pressure plate and flywheel, resulting in the clutch commonly known as "slipping". At the same time, it will increase the cost of fuel and increase the cost of cars.

　　因此，除了起動、換擋和低速制動需要踩緊離合器踏板，不要沒有東西踩緊離合器，或者把腳放在離合器踏板上。同時，還必須掌握正確使用離合器的技巧。正確操作開始:輕輕抬起離合器踏板,離合器semi-linkage出現時,發動機聲音變得沉重,慢慢拿起離合器踏板,離合器踏板抬起的同時,根據發動機阻力的大小逐漸按下油門踏板,使汽車平穩起步。換擋時正確操作:在交通中換擋時，離合器踏板的操作應迅速，不要出現半聯動現象，否則會加速離合器片的磨損。此外，操作時要注意配合油門，不要一邊踩油門一邊踩離合器踏板。

　　Therefore, in addition to starting, shifting and low-speed braking, it is necessary to step on the clutch pedal. Do not step on the clutch without anything, or put your foot on the clutch pedal. At the same time, we must master the skills of using the clutch correctly. Correct operation start: gently lift the clutch pedal, when the clutch semi linkage appears, the engine sound becomes heavy, slowly pick up the clutch pedal, while lifting the clutch pedal, gradually press the accelerator pedal according to the size of the engine resistance, so as to make the car start smoothly. Correct operation during shifting: when shifting in traffic, the operation of clutch pedal shall be rapid, without semi linkage, otherwise the wear of clutch plate will be accelerated. In addition, pay attention to cooperate with the accelerator during operation, and do not step on the clutch pedal while stepping on the accelerator.

　　以上是濟南奧迪汽車維修公司小編為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://www.yiyili.com

　　These are the relevant contents introduced by Jinan Audi automobile maintenance company. If you want to know more, please visit the website: http://www.yiyili.com